Bamiko
check before installation
ambient temperature
For best performance, the swiwmear dryer must be installed only in place with ambient temperature bellow 40°C.
power source
Make sure that you have access to power. The power cord is 2,5 meters long and can be either pluged directly to the socket or hard wired.
water disposal
Swimwear dryer comes with 75 cm long drain hose that can be connected to the waste outlet/drain in the floor or PE water container.
solid wall
Our wall mounted swimwear dryer needs a solid wall that can support at least 30 kg (50 kg when installed with PE water container.
items required
To install the dryer you will need masondry drill, spirit level, tape measure, marker pen, everything else is supplied free of charge.
01
Remove the swimear dryer from the packaging
Take the swimeaer dryer out of the package, remove the red transit bar at the bottom of the dryer, fully pull down the drain hose from the swiwmear dryer until you see a white mark and check that the RCCB is in the "ON" possition, if not, flip it "ON". Remember to keep all the packaging material including the transit bar and foam padding.
02
Install the swimwear dryer onto the wall
After selectiong the right place, measure the correct height and install the wall bracket by drilling 6 holes, insert wall plugs and tighthen the wall bracket in place by supplied crews. Place the swimwear dryer on top of the wall bracket and make sure that the dryer is securely locked in. Then install the securing bracket at the bottom of the dryer - this will keep the dryer safe.
If you have a water container, install the container wall bracket bellow the dryer, too.
03
Connect the swimwear dryer to power and drain
Once the swimwar dryer is installed, connect it to the power. The dryer could be connected either directly to the socket (if local norms and regulation allows it) or hard wired. Remember that all electrical connections should be done by a qualified electrician.
Make sure that the drain hose is fully pulled down from the swimwear dryer and that you see the white mark and connect it to the wastewater outlet in the wall/floor. If you are using PE water container, simply shorten the drain hose 5 - 10 cm bellow the top of the water container and insert it throught the hole inside the water container.
04
Put the wall user manual above the dryer and give it a spin
Place the bilingual wall user manual above the swimwear dryer and give it its frist spin with wet swimwear.
most common problems durign installtion
transit bar
The red transit bar at the bottom of the dryer needs to be removed before first use of the product! If not removed, the swimwear dryer will not work correctly and could be very noisy.
drain hose
The drain hose must be pulled down from the swimwear dryer untill you see a white mark. If you do not see it, the drain hose is not pulled down enough and the water will drip on the floor.
rccb
Make sure the RCCB is in the "ON" possition before first use of the product. Sometimes it trips off during transportation. If it is not switched "ON" the swimwear dryer will not work.